Network Working Group W. Ladd
Internet-Draft UC Berkeley
Intended status: Informational B. Kaduk, Ed.
Expires: April 19, 2018 Akamai
October 16, 2017
SPAKE2, a PAKE
draft-irtf-cfrg-spake2-04
Abstract
This Internet-Draft describes SPAKE2, a secure, efficient password
based key exchange protocol.
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at https://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on April 19, 2018.
Copyright Notice
Copyright (c) 2017 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(https://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Ladd & Kaduk Expires April 19, 2018 [Page 1]
Internet-Draft SPAKE2, a PAKE October 2017
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Definition of SPAKE2 . . . . . . . . . . . . . . . . . . . . 2
3. Table of points for common groups . . . . . . . . . . . . . . 3
4. Security Considerations . . . . . . . . . . . . . . . . . . . 5
5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 6
6. Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . 6
7. References . . . . . . . . . . . . . . . . . . . . . . . . . 6
Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 7
1. Introduction
This document describes a means for two parties that share a password
to derive a shared key. This method is compatible with any group, is
computationally efficient, and has a strong security proof.
2. Definition of SPAKE2
2.1. Setup
Let G be a group in which the Diffie-Hellman problem is hard of order
ph, with p a big prime and h a cofactor. We denote the operations in
the group additively. Let H be a hash function from arbitrary
strings to bit strings of a fixed length. Common choices for H are
SHA256 or SHA512. We assume there is a representation of elements of
G as byte strings: common choices would be SEC1 uncompressed [SEC1]
for elliptic curve groups or big endian integers of a particular
length for prime field DH.
|| denotes concatenation of strings. We also let len(S) denote the
length of a string in bytes, represented as an eight-byte little-
endian number.
We fix two elements M and N as defined in the table in this document
for common groups, as well as a generator G of the group. G is
specified in the document defining the group, and so we do not recall
it here.
Let A and B be two parties. We will assume that A and B are also
representations of the parties such as MAC addresses or other names
(hostnames, usernames, etc). We assume they share an integer w.
Typically w will be the hash of a user-supplied password, truncated
and taken mod p. Protocols using this protocol must define the
method used to compute w: it may be necessary to carry out
normalization. The hashing algorithm SHOULD be designed to slow down
brute force attackers.
Ladd & Kaduk Expires April 19, 2018 [Page 2]
Internet-Draft SPAKE2, a PAKE October 2017
We present two protocols below. Note that it is insecure to use the
same password with both protocols, this MUST NOT be done.
2.2. SPAKE2
A picks x randomly and uniformly from the integers in [0,ph)
divisible by h, and calculates X=xG and T=wM+X, then transmits T to
B.
B selects y randomly and uniformly from the integers in [0,ph),
divisible by h and calculates Y=yG, S=wN+Y, then transmits S to A.
Both A and B calculate a group element K. A calculates it as
x(S-wN), while B calculates it as y(T-wM). A knows S because it has
received it, and likewise B knows T.
This K is a shared secret, but the scheme as described is not secure.
K MUST be combined with the values transmitted and received via a
hash function to have a secure protocol. If higher-level protocols
prescribe a method for doing so, that SHOULD be used. Otherwise we
can compute K' as H(len(A)||A||len(B)||B||len(S)||S||
len(T)||T||len(K)||K || len(w) || w) and use K' as the key.
2.3. SPAKE2+
This protocol and security proof appear in [TDH]. We use the same
setup as for SPAKE2, except that we have two secrets, w0 and w1. The
server, here Bob, stores L=w1*g and w0.
When executing SPAKE2+, A selects x uniformly at random from the
numbers in the range [0, ph) divisible by h, and lets X=xG+w0*M, then
transmits X to B. B selects y uniformly at random from the numbers
in [0, ph) divisible by h, then computes Y=yG+w0*N, and transmits it
to Alice.
A computes Z as x(Y-w0*N), and V as w1(Y-w0*N). B computes Z as y(X-
w0*M) and V as yL. Both share Z and V as common keys. It is
essential that both Z and V be used in combination with the
transcript to derive the keying material. For higher-level protocols
without sufficient transcript hashing, let K' be
H(len(A)||A||len(B)||B||len(X)||X||len(Y)||Y||len(Z)||Z||len(V)||V)
and use K' as the established key.
3. Table of points for common groups
Every curve presented in the table below has an OID from [RFC5480].
We construct a string using the OID and the needed constant, for
instance "1.3.132.0.35 point generation seed (M)" for P-512. This
Ladd & Kaduk Expires April 19, 2018 [Page 3]
Internet-Draft SPAKE2, a PAKE October 2017
string is turned into an infinite sequence of bytes by hashing with
SHA256, and hashing that output again to generate the next 32 bytes,
and so on. This pattern is repeated for each group and value, with
the string modified appropriately.
The initial segment of bytes of length equal to that of an encoded
group element is taken, and is then formatted as required for the
group. In the case of Weierstrass points, this means setting the
first byte to 0x02 or 0x03 depending on the low-order bit. For
Ed25519 style formats this means taking all the bytes as the
representation of the group element. This string of bytes is then
interpreted as a point in the group. If this is impossible, then the
next non-overlapping segment of sufficient length is taken. We
multiply that point by the cofactor h, and if that is not the
identity, output it.
These bytestrings are compressed points as in [SEC1] for curves from
[SEC1].
For P256:
M =
02886e2f97ace46e55ba9dd7242579f2993b64e16ef3dcab95afd497333d8fa12f
N =
03d8bbd6c639c62937b04d997f38c3770719c629d7014d49a24b4f98baa1292b49
For P384:
M =
030ff0895ae5ebf6187080a82d82b42e2765e3b2f8749c7e05eba366434b363d3dc
36f15314739074d2eb8613fceec2853
N =
02c72cf2e390853a1c1c4ad816a62fd15824f56078918f43f922ca21518f9c543bb
252c5490214cf9aa3f0baab4b665c10
For P521:
M =
02003f06f38131b2ba2600791e82488e8d20ab889af753a41806c5db18d37d85608
cfae06b82e4a72cd744c719193562a653ea1f119eef9356907edc9b56979962d7aa
N =
0200c7924b9ec017f3094562894336a53c50167ba8c5963876880542bc669e494b25
32d76c5b53dfb349fdf69154b9e0048c58a42e8ed04cef052a3bc349d95575cd25
The following python snippet generates the above points:
Ladd & Kaduk Expires April 19, 2018 [Page 4]
Internet-Draft SPAKE2, a PAKE October 2017
def canon_pointstr(self, s):
return chr(ord(s[0]) & 1 | 2) + s[1:]
def iterated_hash(seed, n):
h = seed
for i in xrange(n):
h = SHA256.new(h).digest()
return h
def bighash(seed, start, sz):
n = -(-sz // 32)
hashes = [iterated_hash(seed, i) for i in xrange(start, start + n)]
return ''.join(hashes)[:sz]
def gen_point(seed, ec, order):
for i in xrange(1, 1000):
pointstr = ec.canon_pointstr(bighash(seed, i, ec.nbytes_point()))
try:
p = ec.decode_point(pointstr)
if ec.mul(p, order) == ec.identity():
return pointstr, i
except Exception:
pass
4. Security Considerations
A security proof of SPAKE2 for prime order groups is found in [REF].
Note that the choice of M and N is critical for the security proof.
The generation method specified in this document is designed to
eliminate concerns related to knowing discrete logs of M and N.
SPAKE2+ appears in [TDH], along with proof.
There is no key-confirmation as this is a one round protocol. It is
expected that a protocol using this key exchange mechanism provides
key confirmation separately if desired.
Elements should be checked for group membership: failure to properly
validate group elements can lead to attacks. In particular it is
essential to verify that received points are valid compressions of
points on an elliptic curve when using elliptic curves. It is not
necessary to validate membership in the prime order subgroup: the
multiplication by cofactors eliminates this issue.
The choices of random numbers MUST BE uniform. Note that to pick a
random multiple of h in [0, ph) one can pick a random integer in
[0,p) and multiply by h. Reuse of ephemerals results in dictionary
attacks and MUST NOT be done.
Ladd & Kaduk Expires April 19, 2018 [Page 5]
Internet-Draft SPAKE2, a PAKE October 2017
SPAKE2 does not support augmentation. As a result, the server has to
store a password equivalent. This is considered a significant
drawback, and so SPAKE2+ also appears in this document.
As specified the shared secret K is not suitable for use as a shared
key. It MUST be passed to a hash function along with the public
values used to derive it and the party identities to avoid attacks.
In protocols which do not perform this separately, the value denoted
K' MUST be used instead.
5. IANA Considerations
No IANA action is required.
6. Acknowledgments
Special thanks to Nathaniel McCallum for generation of test vectors.
Thanks to Mike Hamburg for advice on how to deal with cofactors.
Greg Hudson suggested addition of warnings on the reuse of x and y.
Thanks to Fedor Brunner, Adam Langley, and the members of the CFRG
for comments and advice. Trevor Perrin informed me of SPAKE2+.
7. References
[REF] Abdalla, M. and D. Pointcheval, "Simple Password-Based
Encrypted Key Exchange Protocols.", Feb 2005.
Appears in A. Menezes, editor. Topics in Cryptography-
CT-RSA 2005, Volume 3376 of Lecture Notes in Computer
Science, pages 191-208, San Francisco, CA, US. Springer-
Verlag, Berlin, Germany.
[RFC5480] Turner, S., Brown, D., Yiu, K., Housley, R., and T. Polk,
"Elliptic Curve Cryptography Subject Public Key
Information", RFC 5480, DOI 10.17487/RFC5480, March 2009,
.
[SEC1] SEC, "STANDARDS FOR EFFICIENT CRYPTOGRAPHY, "SEC 1:
Elliptic Curve Cryptography", version 2.0", May 2009.
[TDH] Cash, D., Kiltz, E., and V. Shoup, "The Twin-Diffie
Hellman Problem and Applications", 2008.
EUROCRYPT 2008. Volume 4965 of Lecture notes in Computer
Science, pages 127-145. Springer-Verlag, Berlin, Germany.
Ladd & Kaduk Expires April 19, 2018 [Page 6]
Internet-Draft SPAKE2, a PAKE October 2017
Authors' Addresses
Watson Ladd
UC Berkeley
Email: watsonbladd@gmail.com
Benjamin Kaduk (editor)
Akamai Technologies
Email: kaduk@mit.edu
Ladd & Kaduk Expires April 19, 2018 [Page 7]